ParkZone F4U-1A Corsair Instrukcja Obsługi Pobierz pdf (Strona 9)







2.875in(73.0mm)



NOTICE: Alwaysensuretheretractsandwheelsareinstalledsothatthereare

noobstructionswhenextendingandretractingthestruts.Failuretodosocould

result in damage to the aircraft or gear.

1. Measureandmark2.875inches(73.0mm)belowthecoilofthestrut,then

cut off the strut (A).

2. Installtheincludedwheels()ontheretractaxles(C)usingthewheel

collars (D)andsetscrews(E).Alwaysinstallthewheelbushingfacingthe

insideofthewheelaxletoensurethewheelrollsfreely.

3. Looselyttheretractaxlesonthelandinggearstruts(F)usingtheaxle

screws().

4. Whereinstalled,removethe8screws(H)andthelandinggeardoors(I)

fromthewing.

5. Install the main retracts (J)inthewingusingthe8screwsremovedfrom

the landing gear doors and the left and right retract plates.

6. Connect the main retracts to the gearharnessextensions( in the fuse-

lage.Installthewingaccordingtopreviouswinginstallationinstructions.

7. Ensurethewheelsmovefreelyinandoutofthewheelwellswhen

extendingandretracting,thentightentheaxlescrewsonthestruts.

Extendthelandinggearandmakesurethewheelhasasmallamountof

toe-inforpropergroundhandling.Useametalletomakeatspotsonboth

sidesofthestrutsotheaxlescrewscanbetightened.

Applyasmallamountofthreadlocktotheaxlescrewsandsetscrewsin

thewheelcollarstosecurethewheelstothestruts.

Itmaybenecessarytoremoveasmallamountoffoamfortheconnector

oftheretracttositushunderthetapeonthebottomofthewing.

3X15mm(4)





1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Brak uwag

ParkZone F4U-1A Corsair Instrukcja Obsługi Strona 9